product/category = http://www.oasisfloral.my/category
Absorbit Dye can apply to any flowers. Customize your flowers with colors.
-For best results use flowers that have been dry packed and stored in the cooler.
-Quickness of dye absorption varies with flower type and variety as well as their hydration state.
-If flowers have already been hydrated set them out of water for about 3-6 hours before dyeing.
-Use warm (100-110 °F) water to dissolve dye.
-Mix thoroughly 2-3 teaspoons of Absorbit per quart of warm water : 8-12 teaspoons per gallon.
-Strip lower foliage and recut stems.
-Place stems in dye solution for 30-60 minutes. Remove flowers from dye solution at the first sign of color above the calyx. Then rinse dye from stems and recut.
-Transfer to water with flower food. This step allows the dye remaining in the stem to travel upwards and intensify the blossom color.
-Do not increase concentration of dye. Formulation includes a wetting agent that is pre-calibrated. Increasing the wetting agent will actually deter the uptake rather than its prescribed enhancement.